T10 Bulb On Signal Lamp

Accessories that you need


Drill the hole at the position that shown on the above picture. At the back of the signal cover. Becareful because the drill bit can damaged the signal cover.


Used this bit to expand the hole


Expand the hole according to the socket


The hole that had been drilled


Use the vacuum cleaner to clean the dust


The T10 bulb with the socket than can be take from meter or dim light


Put the socket into the hole that had been drill before this


Use silicon or the wind screen sealant to avoid the socket from water


Test the bullb using 12 Volt voltage


Connect the socket according to the picture abobe and tap the wire to the small light behind that headlamp.



Final result